6e7df1d151
At this point, the remaining places where we have a symbol that is defined as CONFIG_... are in fairly odd locations. While as much dead code has been removed as possible, some of these locations are simply less obvious at first. In other cases, this code is used, but was defined in such a way as to have been missed by earlier checks. Perform a rename of all such remaining symbols to be CFG_... rather than CONFIG_... Signed-off-by: Tom Rini <trini@konsulko.com> Reviewed-by: Simon Glass <sjg@chromium.org>
29 lines
969 B
Plaintext
29 lines
969 B
Plaintext
U-Boot config options used in fec_mxc.c
|
|
|
|
CONFIG_FEC_MXC
|
|
Selects fec_mxc.c to be compiled into u-boot. Can read out the
|
|
ethaddr from the SoC eFuses (see below).
|
|
|
|
CONFIG_MII
|
|
Must be defined if CONFIG_FEC_MXC is defined.
|
|
|
|
CFG_FEC_MXC_SWAP_PACKET
|
|
Forced on iff MX28.
|
|
Swaps the bytes order of all words(4 byte units) in the packet.
|
|
This should not be specified by a board file. It is cpu specific.
|
|
|
|
CONFIG_PHYLIB
|
|
fec_mxc supports PHYLIB and should be used for new boards.
|
|
|
|
CONFIG_FEC_MXC_NO_ANEG
|
|
Relevant only if PHYLIB not used. Skips auto-negotiation restart.
|
|
|
|
CFG_FEC_MXC_PHYADDR
|
|
Optional, selects the exact phy address that should be connected
|
|
and function fecmxc_initialize will try to initialize it.
|
|
|
|
Reading the ethaddr from the SoC eFuses:
|
|
if CONFIG_FEC_MXC is defined and the U-Boot environment does not contain the
|
|
ethaddr variable, then its value gets read from the corresponding eFuses in
|
|
the SoC. See the README files of the specific SoC for details.
|