u-boot/configs/Cubietruck_plus_defconfig
Samuel Holland 7d5b17cca6 sunxi: Switch to PMIC USB power supply VBUS detection
Update boards to use the USB power supply driver, as referenced in the
device tree, instead of a virtual GPIO. This removes the need for some
DM-incompatible special cases in the GPIO driver.

The following five boards used AXP0-VBUS-DETECT in their config, but are
missing the "usb0_vbus_power-supply" property in their device tree:
 - Ainol_AW1_defconfig / sun7i-a20-ainol-aw1
 - Cubieboard4_defconfig / sun9i-a80-cubieboard4
 - Merrii_A80_Optimus_defconfig / sun9i-a80-optimus
 - Yones_Toptech_BD1078_defconfig / sun7i-a20-yones-toptech-bd1078
 - Yones_Toptech_BS1078_V2_defconfig /
   sun6i-a31s-yones-toptech-bs1078-v2

None of those five boards have the MUSB controller (USB OTG) enabled in
their device trees, so this change should not break anything for them.

Additionally, the following board intentionally omits the property
because VBUS is always enabled:
 - Nintendo_NES_Classic_Edition_defconfig /
   sun8i-r16-nintendo-nes-classic

The PHY driver already assumes VBUS is enabled when no detection method
is available, so again this will not cause any problems.

Signed-off-by: Samuel Holland <samuel@sholland.org>
Reviewed-by: Andre Przywara <andre.przywara@arm.com>
Signed-off-by: Andre Przywara <andre.przywara@arm.com>
2023-04-28 01:30:05 +01:00

31 lines
773 B
Plaintext

CONFIG_ARM=y
CONFIG_ARCH_SUNXI=y
CONFIG_DEFAULT_DEVICE_TREE="sun8i-a83t-cubietruck-plus"
CONFIG_SPL=y
CONFIG_MACH_SUN8I_A83T=y
CONFIG_DRAM_CLK=672
CONFIG_DRAM_ZQ=15355
CONFIG_DRAM_ODT_EN=y
CONFIG_MMC_SUNXI_SLOT_EXTRA=2
CONFIG_USB0_VBUS_PIN="AXP0-VBUS-ENABLE"
CONFIG_USB0_ID_DET="PH11"
CONFIG_USB1_VBUS_PIN="PD29"
CONFIG_USB2_VBUS_PIN="PL6"
CONFIG_I2C0_ENABLE=y
CONFIG_AXP_GPIO=y
# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
CONFIG_CONSOLE_MUX=y
CONFIG_SPL_SYS_I2C_LEGACY=y
CONFIG_SYS_I2C_MVTWSI=y
CONFIG_SYS_I2C_SLAVE=0x7f
CONFIG_SYS_I2C_SPEED=400000
CONFIG_PHY_REALTEK=y
CONFIG_SUN8I_EMAC=y
CONFIG_REGULATOR_AXP_USB_POWER=y
CONFIG_AXP_DLDO3_VOLT=2500
CONFIG_AXP_DLDO4_VOLT=3300
CONFIG_AXP_FLDO1_VOLT=1200
CONFIG_USB_EHCI_HCD=y
CONFIG_USB_OHCI_HCD=y
CONFIG_USB_MUSB_HOST=y