1a1d48e36a
All K3 boards now are secure by default, instead of setting this in each defconfig, make it implied by the ARCH config. The only exception is IOT2050, which I do not believe will have any problems with being a TI_SECURE_DEVICE, but for now turn it off to keep its config the same. Signed-off-by: Andrew Davis <afd@ti.com> Tested-by: Tom Rini <trini@konsulko.com>
179 lines
4.5 KiB
Plaintext
179 lines
4.5 KiB
Plaintext
CONFIG_ARM=y
|
|
CONFIG_ARCH_K3=y
|
|
CONFIG_SYS_MALLOC_LEN=0x2000000
|
|
CONFIG_SYS_MALLOC_F_LEN=0x70000
|
|
CONFIG_SPL_GPIO=y
|
|
CONFIG_SPL_LIBCOMMON_SUPPORT=y
|
|
CONFIG_SPL_LIBGENERIC_SUPPORT=y
|
|
CONFIG_SOC_K3_J721E=y
|
|
CONFIG_K3_EARLY_CONS=y
|
|
CONFIG_TARGET_J721E_R5_EVM=y
|
|
CONFIG_HAS_CUSTOM_SYS_INIT_SP_ADDR=y
|
|
CONFIG_CUSTOM_SYS_INIT_SP_ADDR=0x41cf59f0
|
|
CONFIG_ENV_SIZE=0x20000
|
|
CONFIG_DM_GPIO=y
|
|
CONFIG_SPL_DM_SPI=y
|
|
CONFIG_DEFAULT_DEVICE_TREE="k3-j721e-r5-common-proc-board"
|
|
CONFIG_SPL_TEXT_BASE=0x41c00000
|
|
CONFIG_DM_RESET=y
|
|
CONFIG_SPL_MMC=y
|
|
CONFIG_SPL_SERIAL=y
|
|
CONFIG_SPL_DRIVERS_MISC=y
|
|
CONFIG_SPL_STACK_R_ADDR=0x82000000
|
|
CONFIG_SPL_SIZE_LIMIT=0xf59f0
|
|
CONFIG_SPL_SIZE_LIMIT_PROVIDE_STACK=0x4000
|
|
CONFIG_SPL_FS_FAT=y
|
|
CONFIG_SPL_LIBDISK_SUPPORT=y
|
|
CONFIG_SPL_SPI_FLASH_SUPPORT=y
|
|
CONFIG_SPL_SPI=y
|
|
# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
|
|
CONFIG_SPL_LOAD_FIT=y
|
|
CONFIG_SPL_LOAD_FIT_ADDRESS=0x80080000
|
|
CONFIG_OF_BOARD_SETUP=y
|
|
CONFIG_USE_BOOTCOMMAND=y
|
|
# CONFIG_DISPLAY_CPUINFO is not set
|
|
CONFIG_SPL_SIZE_LIMIT_SUBTRACT_GD=y
|
|
CONFIG_SPL_SIZE_LIMIT_SUBTRACT_MALLOC=y
|
|
CONFIG_SPL_MAX_SIZE=0xf59f0
|
|
CONFIG_SPL_HAS_BSS_LINKER_SECTION=y
|
|
CONFIG_SPL_BSS_START_ADDR=0x41cf59f0
|
|
CONFIG_SPL_BSS_MAX_SIZE=0xa000
|
|
CONFIG_SPL_BOARD_INIT=y
|
|
CONFIG_SPL_STACK_R=y
|
|
CONFIG_SPL_SEPARATE_BSS=y
|
|
CONFIG_SPL_SYS_MALLOC=y
|
|
CONFIG_SPL_HAS_CUSTOM_MALLOC_START=y
|
|
CONFIG_SPL_CUSTOM_SYS_MALLOC_ADDR=0x84000000
|
|
CONFIG_SPL_SYS_MALLOC_SIZE=0x1000000
|
|
CONFIG_SPL_EARLY_BSS=y
|
|
CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR=y
|
|
CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR=0x400
|
|
CONFIG_SPL_DMA=y
|
|
CONFIG_SPL_ENV_SUPPORT=y
|
|
CONFIG_SPL_FS_EXT4=y
|
|
CONFIG_SPL_I2C=y
|
|
CONFIG_SPL_DM_MAILBOX=y
|
|
CONFIG_SPL_MTD_SUPPORT=y
|
|
CONFIG_SPL_DM_SPI_FLASH=y
|
|
CONFIG_SPL_NOR_SUPPORT=y
|
|
CONFIG_SPL_DM_RESET=y
|
|
CONFIG_SPL_POWER_DOMAIN=y
|
|
CONFIG_SPL_RAM_SUPPORT=y
|
|
CONFIG_SPL_RAM_DEVICE=y
|
|
CONFIG_SPL_REMOTEPROC=y
|
|
# CONFIG_SPL_SPI_FLASH_TINY is not set
|
|
CONFIG_SPL_SPI_FLASH_SFDP_SUPPORT=y
|
|
CONFIG_SPL_SPI_LOAD=y
|
|
CONFIG_SYS_SPI_U_BOOT_OFFS=0x80000
|
|
CONFIG_SPL_YMODEM_SUPPORT=y
|
|
CONFIG_HUSH_PARSER=y
|
|
CONFIG_SYS_MAXARGS=64
|
|
CONFIG_SYS_BOOTM_LEN=0x4000000
|
|
CONFIG_CMD_DFU=y
|
|
# CONFIG_CMD_FLASH is not set
|
|
CONFIG_CMD_GPT=y
|
|
CONFIG_CMD_MMC=y
|
|
CONFIG_CMD_REMOTEPROC=y
|
|
# CONFIG_CMD_SETEXPR is not set
|
|
CONFIG_CMD_TIME=y
|
|
CONFIG_CMD_FAT=y
|
|
CONFIG_CMD_MTDPARTS=y
|
|
CONFIG_OF_CONTROL=y
|
|
CONFIG_SPL_OF_CONTROL=y
|
|
CONFIG_SPL_MULTI_DTB_FIT=y
|
|
CONFIG_SPL_OF_LIST="k3-j721e-r5-common-proc-board k3-j721e-r5-sk"
|
|
CONFIG_SPL_MULTI_DTB_FIT_NO_COMPRESSION=y
|
|
CONFIG_ENV_OVERWRITE=y
|
|
CONFIG_SYS_RELOC_GD_ENV_ADDR=y
|
|
CONFIG_SPL_DM=y
|
|
CONFIG_SPL_DM_SEQ_ALIAS=y
|
|
CONFIG_REGMAP=y
|
|
CONFIG_SPL_REGMAP=y
|
|
CONFIG_SYSCON=y
|
|
CONFIG_SPL_SYSCON=y
|
|
CONFIG_SPL_OF_TRANSLATE=y
|
|
CONFIG_CLK=y
|
|
CONFIG_SPL_CLK=y
|
|
CONFIG_SPL_CLK_CCF=y
|
|
CONFIG_SPL_CLK_K3_PLL=y
|
|
CONFIG_SPL_CLK_K3=y
|
|
CONFIG_SYS_DFU_DATA_BUF_SIZE=0x5000
|
|
CONFIG_DMA_CHANNELS=y
|
|
CONFIG_TI_K3_NAVSS_UDMA=y
|
|
CONFIG_TI_SCI_PROTOCOL=y
|
|
CONFIG_DA8XX_GPIO=y
|
|
CONFIG_DM_PCA953X=y
|
|
CONFIG_DM_I2C=y
|
|
CONFIG_I2C_SET_DEFAULT_BUS_NUM=y
|
|
CONFIG_SYS_I2C_OMAP24XX=y
|
|
CONFIG_DM_MAILBOX=y
|
|
CONFIG_K3_SEC_PROXY=y
|
|
CONFIG_FS_LOADER=y
|
|
CONFIG_SPL_FS_LOADER=y
|
|
CONFIG_ESM_K3=y
|
|
CONFIG_K3_AVS0=y
|
|
CONFIG_ESM_PMIC=y
|
|
CONFIG_SUPPORT_EMMC_BOOT=y
|
|
CONFIG_SPL_MMC_HS200_SUPPORT=y
|
|
CONFIG_MMC_SDHCI=y
|
|
CONFIG_SPL_MMC_SDHCI_ADMA=y
|
|
CONFIG_MMC_SDHCI_AM654=y
|
|
CONFIG_MTD=y
|
|
CONFIG_DM_MTD=y
|
|
CONFIG_MTD_NOR_FLASH=y
|
|
CONFIG_FLASH_SHOW_PROGRESS=0
|
|
CONFIG_CFI_FLASH=y
|
|
CONFIG_SYS_FLASH_USE_BUFFER_WRITE=y
|
|
CONFIG_FLASH_CFI_MTD=y
|
|
CONFIG_SYS_FLASH_CFI=y
|
|
CONFIG_DM_SPI_FLASH=y
|
|
CONFIG_SPI_FLASH_SFDP_SUPPORT=y
|
|
CONFIG_SPI_FLASH_STMICRO=y
|
|
CONFIG_PINCTRL=y
|
|
# CONFIG_PINCTRL_GENERIC is not set
|
|
CONFIG_SPL_PINCTRL=y
|
|
# CONFIG_SPL_PINCTRL_GENERIC is not set
|
|
CONFIG_PINCTRL_SINGLE=y
|
|
CONFIG_POWER_DOMAIN=y
|
|
CONFIG_TI_POWER_DOMAIN=y
|
|
CONFIG_DM_PMIC=y
|
|
CONFIG_PMIC_TPS65941=y
|
|
CONFIG_DM_REGULATOR=y
|
|
CONFIG_SPL_DM_REGULATOR=y
|
|
CONFIG_DM_REGULATOR_TPS65941=y
|
|
CONFIG_K3_SYSTEM_CONTROLLER=y
|
|
CONFIG_REMOTEPROC_TI_K3_ARM64=y
|
|
CONFIG_RESET_TI_SCI=y
|
|
CONFIG_DM_SERIAL=y
|
|
CONFIG_SOC_DEVICE=y
|
|
CONFIG_SOC_DEVICE_TI_K3=y
|
|
CONFIG_SOC_TI=y
|
|
CONFIG_SPI=y
|
|
CONFIG_DM_SPI=y
|
|
CONFIG_CADENCE_QSPI=y
|
|
CONFIG_HAS_CQSPI_REF_CLK=y
|
|
CONFIG_CQSPI_REF_CLK=133333333
|
|
CONFIG_SYSRESET=y
|
|
CONFIG_SPL_SYSRESET=y
|
|
CONFIG_SYSRESET_TI_SCI=y
|
|
CONFIG_TIMER=y
|
|
CONFIG_SPL_TIMER=y
|
|
CONFIG_OMAP_TIMER=y
|
|
CONFIG_USB=y
|
|
CONFIG_DM_USB_GADGET=y
|
|
CONFIG_SPL_DM_USB_GADGET=y
|
|
CONFIG_USB_CDNS3=y
|
|
CONFIG_USB_CDNS3_GADGET=y
|
|
CONFIG_SPL_USB_CDNS3_GADGET=y
|
|
CONFIG_USB_GADGET=y
|
|
CONFIG_SPL_USB_GADGET=y
|
|
CONFIG_USB_GADGET_MANUFACTURER="Texas Instruments"
|
|
CONFIG_USB_GADGET_VENDOR_NUM=0x0451
|
|
CONFIG_USB_GADGET_PRODUCT_NUM=0x6163
|
|
CONFIG_USB_GADGET_DOWNLOAD=y
|
|
CONFIG_SPL_DFU=y
|
|
CONFIG_FS_EXT4=y
|
|
CONFIG_FS_FAT_MAX_CLUSTSIZE=16384
|
|
CONFIG_LIB_RATIONAL=y
|
|
CONFIG_SPL_LIB_RATIONAL=y
|