48 lines
2.2 KiB
Plaintext
48 lines
2.2 KiB
Plaintext
Hardware requirements
|
|
=====================
|
|
- LPCXpresso55S69 board
|
|
- Personal Computer
|
|
- FreeMASTER 3.0 or later installed on PC
|
|
- Serial line or USB equipment as needed to connect over selected interface.
|
|
|
|
Board settings
|
|
============
|
|
By default, the demo is configured for standard serial (UART) communication. It may
|
|
be changed to other interface in MCUXpresso ConfigTools. Run the MCUXpresso ConfigTools,
|
|
select the Peripherals tool and open the Middleware/FreeMASTER component configuration.
|
|
Refer to the list of recommended communication options below and make the selection in
|
|
the FreeMASTER configuration page. Note that the other communication interfaces may require
|
|
to use different physical connections, such as serial or USB ports.
|
|
|
|
Recommended communication options
|
|
=================================
|
|
- 'SERIAL' at FLEXCOMM0 module connected to virtual serial port of the debugger USB interface.
|
|
- 'Packet-driven BDM' using the debugger interface (use flash-based build targets only).
|
|
|
|
Prepare the demo
|
|
===============
|
|
1. Interconnect the host PC and the target microcontroller board using the selected
|
|
interface cable.
|
|
2. Compile and download the program to the target microcontroller.
|
|
3. Run and resume application execution when debugger stops in the main() function.
|
|
|
|
If using the Packet-driven BDM interface
|
|
========================================
|
|
4. Terminate the debugger session to release the JTAG interface for FreeMASTER use.
|
|
5. Reset the target board to make sure it runs after detaching the debugger.
|
|
|
|
Connect with FreeMASTER
|
|
=======================
|
|
6. Run FreeMASTER, use the Connection Wizard or open Project Options.
|
|
7. Configure Serial or other communication as required by this demo setup.
|
|
8. Start communication, FreeMASTER loads the initial TSA Active Content links in the Welcome page.
|
|
9. Click the "FreeMASTER Demonstration Project (embedded in device)" in the Welcome page.
|
|
10. The demo is now running, you should be able to watch variable values and graphs.
|
|
|
|
More information
|
|
================
|
|
Read more information about FreeMASTER tool at http://www.nxp.com/freemaster.
|
|
Feel free to ask questions and report issues at FreeMASTER's
|
|
community page at https://community.nxp.com/community/freemaster
|
|
|