Embedded_SDK/MCUXpresso_MCXA153
1
0
Fork 0
Code Issues Pull Requests Packages Projects Releases Wiki Activity
master
MCUXpresso_MCXA153/boards/frdmmcxa153/driver_examples/glikey
History
Yilin Sun 35e678394a
Initial commit v2.14.2 
Signed-off-by: Yilin Sun <imi415@imi.moe>
2024-02-11 19:33:06 +08:00
..
armgcc Initial commit v2.14.2 2024-02-11 19:33:06 +08:00
board.c Initial commit v2.14.2 2024-02-11 19:33:06 +08:00
board.h Initial commit v2.14.2 2024-02-11 19:33:06 +08:00
clock_config.c Initial commit v2.14.2 2024-02-11 19:33:06 +08:00
clock_config.h Initial commit v2.14.2 2024-02-11 19:33:06 +08:00
glikey_v3_13.xml Initial commit v2.14.2 2024-02-11 19:33:06 +08:00
glikey.c Initial commit v2.14.2 2024-02-11 19:33:06 +08:00
pin_mux.c Initial commit v2.14.2 2024-02-11 19:33:06 +08:00
pin_mux.h Initial commit v2.14.2 2024-02-11 19:33:06 +08:00
readme.md Initial commit v2.14.2 2024-02-11 19:33:06 +08:00

readme.md

Overview

The GLIKEY Example project is a demonstration program that uses the MCUX SDK software to set up GLIKEY IP peripherial.

SDK version

  • Version: 2.14.2

Toolchain supported

  • IAR embedded Workbench 9.40.2
  • Keil MDK 5.38.1
  • GCC ARM Embedded 12.2
  • MCUXpresso 11.9.0

Hardware requirements

  • Type-C USB cable
  • FRDM-MCXA153 board
  • Personal Computer

Board settings

No special settings are required.

Prepare the Demo

  1. Connect a Type-C USB cable between the host PC and the MCU-Link port(J15) on the target board.
  2. Open a serial terminal with the following settings:
    • 115200 baud rate
    • 8 data bits
    • No parity
    • One stop bit
    • No flow control
  3. Download the program to the target board.
  4. Either press the reset button on your board or launch the debugger in your IDE to begin running the demo.

Running the demo

The log below shows the output of the GLIKEY driver demo in the terminal window:

GLIKEY Peripheral Driver Example

*Success* GLIKEY is not locked

*Success* GLIKEY Sync Reset done

*Success* GLIKEY Start enable done

*Success* GLIKEY Continue enable Step 1 pass

*Success* GLIKEY Continue enable Step 2 pass

*Success* GLIKEY Continue enable Step 3 pass

*Success* GLIKEY Continue enable  Step 4 pass

*Success* GLIKEY Continue enable  Step 5 pass

*Success* GLIKEY Continue enable  Step 6 pass

*Success* GLIKEY Continue enable  Step 7 pass

*Success* GLIKEY Continue enable Step Enable pass

SUCCESS: Register on index 2 can be now written!

*Success* GLIKEY End of operation done

End of example