Yilin Sun
763d32be90
Signed-off-by: Yilin Sun <imi415@imi.moe> |
||
---|---|---|
.. | ||
armgcc | ||
board.c | ||
board.h | ||
board_setup.c | ||
board_setup.h | ||
clock_config.c | ||
clock_config.h | ||
dcd.c | ||
dcd.h | ||
filex_sdcard.c | ||
filex_sdcard_v3_14.xml | ||
fx_sdcard_driver.c | ||
fx_user.h | ||
pin_mux.c | ||
pin_mux.h | ||
readme.md | ||
sdmmc_config.c | ||
sdmmc_config.h | ||
tx_user.h |
readme.md
Overview
The example shows how to use the SD card middleware with Azure RTOS.
This example will print the information of the SD card and format it in FAT format. Then, do some file operation test - create, write, read, close and so on.
SDK version
- Version: 2.15.000
Toolchain supported
- IAR embedded Workbench 9.40.1
- Keil MDK 5.38.1
- GCC ARM Embedded 12.2
- MCUXpresso 11.8.0
Hardware requirements
- Mini/micro USB cable
- EVK-MIMXRT1020 board
- Personal Computer
- Micro SD card
Board settings
Please insert a micro SD card into the card slot.
Prepare the Demo
- Insert a micro SD card into the card slot
- Connect a micro USB cable between the PC host and the OpenSDA USB port on the board.
- Open a serial terminal on PC for OpenSDA serial device with these settings:
- 115200 baud rate
- 8 data bits
- No parity
- One stop bit
- No flow control
- Download the program to the target board.
- Either press the reset button on your board or launch the debugger in your IDE to begin running the demo.
Running the demo
When the example runs successfully, the console will output like:
Start FileX SD Card example Please insert a SD card. SD card inserted. Card size: 15728 MB Card block size: 512 bytes Card block count: 30720000 Voltage: 1.8V Timing mode: SDR104 Formatted SD Card
Creat TEST.TXT Open TEST.TXT Write TEST.TXT Read TEST.TXT Close TEST.TXT
Continue the test (y/n):
If you want to test again, plese select 'y'. If you want to remove the SD card, please select 'n' to end the test.