Yilin Sun
763d32be90
Signed-off-by: Yilin Sun <imi415@imi.moe> |
||
---|---|---|
.. | ||
armgcc | ||
board.c | ||
board.h | ||
clock_config.c | ||
clock_config.h | ||
dcd.c | ||
dcd.h | ||
evkmimxrt1020_sdram_init.jlinkscript | ||
pin_mux.c | ||
pin_mux.h | ||
readme.md | ||
xbara.c | ||
xbara_v3_14.xml |
readme.md
Overview
The Xbara project is a simple demonstration program of the SDK Xbara driver.The intended application of this module is to provide a flexible crossbar switch function that allows any input to be connected to any output under user control.It sets up the Xbara hardware block to trigger a periodic interrupt after every 1 second. When the Xbar interrupt is triggered a message a printed on the UART terminal.
SDK version
- Version: 2.15.000
Toolchain supported
- IAR embedded Workbench 9.40.1
- Keil MDK 5.38.1
- GCC ARM Embedded 12.2
- MCUXpresso 11.8.0
Hardware requirements
- Mini/micro USB cable
- MIMXRT1020-EVK board
- Personal Computer
Board settings
No special settings are required.
Prepare the Demo
- Connect a USB cable between the PC host and the OpenSDA USB port on the board.
- Open a serial terminal with these settings:
- 115200 baud rate
- 8 data bits
- No parity
- One stop bit
- No flow control
- Download the program to the target board.
- Either press the reset button on your board or launch the debugger in your IDE to begin running the example.
Running the demo
These instructions are displayed/shown on the terminal window:
XBARA Peripheral Driver Example.
XBARA interrupt is occurred !
XBARA interrupt is occurred !
XBARA interrupt is occurred !
............................
............................