Overview
========
This example illustrates USBX Device Mass Storage.
Toolchain supported
===================
- IAR embedded Workbench 9.30.1
- Keil MDK 5.37
- GCC ARM Embedded 10.3.1
- MCUXpresso 11.6.0
Hardware requirements
=====================
- Mini/micro USB cable
- EVK-MIMXRT1020 board
- Personal Computer(PC)
Board settings
==============
No special settings are required.
Prepare the Demo
================
1. Connect a USB cable between the host PC and the OpenSDA USB port on the target board.
2. Open a serial terminal with the following settings:
- 115200 baud rate
- 8 data bits
- No parity
- 1 stop bit
- No flow control
3. Compile the demo with the configuration, "flexspi_nor_debug".
4. Write the program to the flash of the target board.
5. Press the reset button on your board to start the demo.
6. Connect a USB cable between the PC and the USB device port of the board.
7. PC can format/read/write this u-disk.
Running the demo
================
After writing the program to the flash of the target board,
press the reset button on your board to start the demo.
The serial port will output:
USBX device mass storage example
Then, connect a USB cable between PC and USB device port
of the board. The serial port will output:
USB MSD device activate
PC will detect a u-disk and can format it. After format
is completed, the PC will display a removable disk and
it can be used as a normal u-disk.
Please note that the USBX Device Mass Storage example use
RAM disk as storage media, data will lost after board is
reset.