Yilin Sun
6baf4427ce
Signed-off-by: Yilin Sun <imi415@imi.moe> |
||
---|---|---|
.. | ||
armgcc | ||
board.c | ||
board.h | ||
clock_config.c | ||
clock_config.h | ||
dcd.c | ||
dcd.h | ||
filex_ram_disk.c | ||
filex_ram_disk_v3_14.xml | ||
fx_user.h | ||
pin_mux.c | ||
pin_mux.h | ||
readme.md | ||
tx_user.h |
readme.md
Overview
This is a small demo of the high-performance FileX FAT file system. It includes setup for a small 34KB RAM disk and a loop that writes and reads a small file.
SDK version
- Version: 2.15.000
Toolchain supported
- IAR embedded Workbench 9.40.1
- Keil MDK 5.38.1
- GCC ARM Embedded 12.2
- MCUXpresso 11.8.0
Hardware requirements
- Mini/micro USB cable
- EVKB-IMXRT1050 board
- Personal Computer
Board settings
No special settings are required.
Prepare the Demo
- Connect a USB cable between the host PC and the OpenSDA USB port on the target board.
- Open a serial terminal with the following settings:
- 115200 baud rate
- 8 data bits
- No parity
- One stop bit
- No flow control
- Compile the demo with the configuration, "flexspi_nor_debug".
- Write the program to the flash of the target board.
- Press the reset button on your board to start the demo.
Running the demo
After writing the program to the flash of the target board, press the reset button on your board to start the demo.
Example output: FILEX example..... Open RAM Disk..... Creat TEST.TXT..... Write TEST.TXT..... Close TEST.TXT..... Close RAM Disk.....