Yilin Sun
6baf4427ce
Signed-off-by: Yilin Sun <imi415@imi.moe> |
||
|---|---|---|
| .. | ||
| armgcc | ||
| board.c | ||
| board.h | ||
| clock_config.c | ||
| clock_config.h | ||
| dcd.c | ||
| dcd.h | ||
| fx_user.h | ||
| netx_duo_ping.c | ||
| netx_duo_ping_v3_14.xml | ||
| nx_user.h | ||
| pin_mux.c | ||
| pin_mux.h | ||
| readme.md | ||
| tx_user.h | ||
readme.md
Overview
This is a small ping demo of the high-performance NetX Duo TCP/IP stack.
SDK version
- Version: 2.15.000
Toolchain supported
- IAR embedded Workbench 9.40.1
- Keil MDK 5.38.1
- GCC ARM Embedded 12.2
- MCUXpresso 11.8.0
Hardware requirements
- Mini/micro USB cable
- Network cable RJ45 standard
- EVKB-IMXRT1050 board
- Personal Computer
Board settings
No special settings are required.
Prepare the Demo
- Connect a USB cable between the host PC and the OpenSDA USB port on the target board.
- Open a serial terminal with the following settings:
- 115200 baud rate
- 8 data bits
- No parity
- One stop bit
- No flow control
- Insert Cable to Ethernet RJ45 port and connect it to a ethernet switch.
- Write the program to the flash of the target board.
- Press the reset button on your board to start the demo.
Running the demo
When the demo is running, the serial port will output:
Start the ping example... MAC address: 00:11:22:33:44:56 DHCP In Progress... IP address: 192.168.2.10 Mask: 255.255.255.0
It shows that the board gets a new IP address, for example, 192.168.2.10. Then, on a PC, use the ping command to ping the new IP address of the board, for example:
$ ping 192.168.2.10 Pinging 192.168.2.10 with 32 bytes of data: Reply from 192.168.2.10: bytes=32 time=5ms TTL=127 Reply from 192.168.2.10: bytes=32 time=4ms TTL=127 Reply from 192.168.2.10: bytes=32 time=3ms TTL=127 Reply from 192.168.2.10: bytes=32 time=2ms TTL=127
It shows that the example program running on the board can handle ping packages.