Yilin Sun
6baf4427ce
Signed-off-by: Yilin Sun <imi415@imi.moe> |
||
---|---|---|
.. | ||
armgcc | ||
board.c | ||
board.h | ||
clock_config.c | ||
clock_config.h | ||
dcd.c | ||
dcd.h | ||
evkbimxrt1050_sdram_init.jlinkscript | ||
lpspi_loopback.bin | ||
lpspi_loopback.c | ||
lpspi_loopback.mex | ||
lpspi_loopback_v3_14.xml | ||
pin_mux.c | ||
pin_mux.h | ||
readme.md |
readme.md
Overview
The lpspi_loopback demo shows how the lpspi do a loopback transfer, LPSPI master will transmit data to itself, so please connect the SOUT pin to SIN pin directly.
SDK version
- Version: 2.15.000
Toolchain supported
- GCC ARM Embedded 12.2
- IAR embedded Workbench 9.40.1
- Keil MDK 5.38.1
- MCUXpresso 11.8.0
Hardware requirements
- Mini/micro USB cable
- EVKB-MIMXRT1050 board
- Personal Computer
Board settings
Remove the resistor R334 and weld 0Ω resistor to R278,R280.
LPSPI:
MASTER connect to MASTER
Pin Name Board Location Pin Name Board Location
SOUT J24-4 SIN J24-5
Prepare the Demo
- Connect a mini USB cable between the PC host and the OpenSDA USB port on the board.
- Open a serial terminal on PC for OpenSDA serial device with these settings:
- 115200 baud rate
- 8 data bits
- No parity
- One stop bit
- No flow control
- Download the program to the target board.
- Either press the reset button on your board or launch the debugger in your IDE to begin running the demo.
Running the demo
When the example runs successfully, you can see the similar information from the terminal as below.
***LPSPI Loopback Demo***
LPSPI loopback test pass!!!