Embedded_SDK/MCUXpresso_MIMXRT1052xxxxB
1
0
Fork 0
Code Issues Pull Requests Projects Releases Wiki Activity
master
MCUXpresso_MIMXRT1052xxxxB/boards/evkbimxrt1050/driver_examples/gpio/input_interrupt
History
Yilin Sun 6baf4427ce
Updated to v2.15.000 
Signed-off-by: Yilin Sun <imi415@imi.moe>
2024-03-18 23:15:10 +08:00
..
armgcc Updated to v2.15.000 2024-03-18 23:15:10 +08:00
board.c Updated to v2.15.000 2024-03-18 23:15:10 +08:00
board.h Updated to v2.15.000 2024-03-18 23:15:10 +08:00
clock_config.c Update SDK to v2.13.0 2023-01-26 09:35:56 +08:00
clock_config.h Update SDK to v2.13.0 2023-01-26 09:35:56 +08:00
dcd.c SDK v2.11.1 2022-04-08 22:46:35 +08:00
dcd.h SDK v2.11.1 2022-04-08 22:46:35 +08:00
evkbimxrt1050_sdram_init.jlinkscript Updated to v2.14.0 2023-11-30 20:55:00 +08:00
gpio_input_interrupt.c SDK v2.11.1 2022-04-08 22:46:35 +08:00
igpio_input_interrupt_v3_14.xml Updated to v2.15.000 2024-03-18 23:15:10 +08:00
pin_mux.c SDK v2.11.1 2022-04-08 22:46:35 +08:00
pin_mux.h SDK v2.11.1 2022-04-08 22:46:35 +08:00
readme.md Updated to v2.15.000 2024-03-18 23:15:10 +08:00

readme.md

Overview

The GPIO Example project is a demonstration program that uses the KSDK software to manipulate the general-purpose outputs. The example is supported by the set, clear registers for each GPIO pin output register.

SDK version

  • Version: 2.15.000

Toolchain supported

  • IAR embedded Workbench 9.40.1
  • Keil MDK 5.38.1
  • GCC ARM Embedded 12.2
  • MCUXpresso 11.8.0

Hardware requirements

  • Mini/micro USB cable
  • EVKB-IMXRT1050 board
  • Personal Computer

Board settings

No special settings are required.

Prepare the Demo

  1. Connect a USB cable between the host PC and the OpenSDA USB port on the target board.
  2. Open a serial terminal with the following settings:
    • 115200 baud rate
    • 8 data bits
    • No parity
    • One stop bit
    • No flow control
  3. Download the program to the target board.
  4. Either press the reset button on your board or launch the debugger in your IDE to begin running the demo.

Running the demo

When the example runs successfully, the following message is displayed in the terminal: If you turn on the SW8 , and "SW8 is turned on" is shown on the terminal window

 GPIO Driver example.

 SW8 is turned on.
 ......