Overview
========
The TPM project is a demonstration program of the SDK TPM driver's input capture feature.
The example sets up a TPM channel for dual-edge capture. Once the input signal is received,
this example will print the capture value.
Toolchain supported
===================
- Keil MDK 5.24a
- IAR embedded Workbench 8.22.2
- GCC ARM Embedded 7-2017-q4-major
- MCUXpresso10.2.0
Hardware requirements
=====================
- Mini USB cable
- MAPS-KS22F256 board & MAPS-DOCK board
- Personal Computer
Board settings
==============
The example is configured to use UART1 with PTE0 and PTE1 pins. To make JLink serial
device work, the jumpers on MAPS-DOCK board should be set as following:
- JP5: UART1 part jumpers connected.
- Connect input to Pin-53.
Prepare the Demo
================
1. Connect a USB cable between the PC host and the OpenSDA USB port on the board.
2. Open a serial terminal with these settings:
- 115200 baud rate
- 8 data bits
- No parity
- One stop bit
- No flow control
3. Download the program to the target board.
4. Either press the reset button on your board or launch the debugger in your IDE to begin running
the demo.
Running the demo
================
When the example runs successfully, you can see information from the terminal as below.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
TPM input capture example
Once the input signal is received the input capture value is printed
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Customization options
=====================
