openocd/tcl/interface/dlp-usb1232h.cfg

#
# DLP Design DLP-USB1232H USB-to-UART/FIFO interface module
#
# http://www.dlpdesign.com/usb/usb1232h.shtml
#
# Schematics for OpenOCD usage:
# http://randomprojects.org/wiki/DLP-USB1232H_and_OpenOCD_based_JTAG_adapter
#

interface ft2232
ft2232_device_desc "Dual RS232-HS"
ft2232_layout usbjtag
ft2232_vid_pid 0x0403 0x6010
Add an interface file for DLP Design DLP-USB1232H. The DLP Design DLP-USB1232H UART/SPI/JTAG module is based on an FTDI FT2232H chip. Among other things, it can used as JTAG programmer if connected to the JTAG target properly. I have successfully wired the module to an Olimex STM32-H103 eval board and flashed a firmware onto that using OpenOCD. The setup details and schematics are documented at: http://randomprojects.org/wiki/DLP-USB1232H_and_OpenOCD_based_JTAG_adapter Change-Id: I5eb9255a61eeece233009bee77d7dc3b5d1afb8b Signed-off-by: Uwe Hermann <uwe@hermann-uwe.de> Reviewed-on: http://openocd.zylin.com/20 Reviewed-by: Spencer Oliver <spen@spen-soft.co.uk> Tested-by: Spencer Oliver <spen@spen-soft.co.uk> 2011-10-13 22:21:06 +00:00			`#`
			`# DLP Design DLP-USB1232H USB-to-UART/FIFO interface module`
			`#`
			`# http://www.dlpdesign.com/usb/usb1232h.shtml`
			`#`
			`# Schematics for OpenOCD usage:`
			`# http://randomprojects.org/wiki/DLP-USB1232H_and_OpenOCD_based_JTAG_adapter`
			`#`

			`interface ft2232`
			`ft2232_device_desc "Dual RS232-HS"`
			`ft2232_layout usbjtag`
			`ft2232_vid_pid 0x0403 0x6010`