1ac220df71
Add another board ... OMAP2420 "H4" board. This won't be very widely used with OpenOCD, but with mainline support in both U-Boot and Linux it at least makes for a more complete set (and another testcase). This is incomplete support in several respects. The ARM11 support is not very deep yet; most registers aren't available, and the ETM can't be hooked up. Plus, there's no script for OMAP-specific stuff like setting up the SDRAM controller. Eventually the same NAND controller driver should work with OMAP2 and OMAP3. git-svn-id: svn://svn.berlios.de/openocd/trunk@2242 b42882b7-edfa-0310-969c-e2dbd0fdcd60
15 lines
426 B
INI
15 lines
426 B
INI
# OMAP2420 SDP board ("H4")
|
|
|
|
source [find target/omap2420.cfg]
|
|
|
|
# NOTE: this assumes you're *NOT* using a TI-14 connector.
|
|
reset_config trst_and_srst separate
|
|
|
|
# Board configs can vary a *LOT* ... parts, jumpers, etc.
|
|
# This GP board boots from cs0 using NOR (2x32M), and also
|
|
# has 64M NAND on cs6.
|
|
flash bank cfi 0x04000000 0x02000000 2 2 $_TARGETNAME
|
|
flash bank cfi 0x06000000 0x02000000 2 2 $_TARGETNAME
|
|
|
|
# vim:syntax tcl
|