d0be1630dc
The Mimas A7 FPGA board has FTDI FT2232 whose channel B is connected to Artix-7 FPGA's JTAG interface. Hence, OpenOCD can easily interface with it via the its ftdi driver interface. Tested to be working great up to 30 MHz. Change-Id: Ieda015fbc6135bf95ad5a069cbf38650da45911e Signed-off-by: Rohit Singh <rohit91.2008@gmail.com> Reviewed-on: http://openocd.zylin.com/4720 Tested-by: jenkins Reviewed-by: Tim "mithro" Ansell <me@mith.ro> Reviewed-by: Robert Jordens <jordens@gmail.com> Reviewed-by: Paul Fertser <fercerpav@gmail.com>
37 lines
1.2 KiB
INI
37 lines
1.2 KiB
INI
#
|
|
# Numato Mimas A7 - Artix 7 FPGA Board
|
|
#
|
|
# https://numato.com/product/mimas-a7-artix-7-fpga-development-board-with-ddr-sdram-and-gigabit-ethernet
|
|
#
|
|
# Note: Connect external DC power supply if programming a heavy design onto FPGA.
|
|
# Programming while powering via USB may lead to programming failure.
|
|
# Therefore, prefer external power supply.
|
|
|
|
interface ftdi
|
|
ftdi_device_desc "Mimas Artix 7 FPGA Module"
|
|
ftdi_vid_pid 0x2a19 0x1009
|
|
|
|
# channel 0 is for custom purpose by users (like uart, fifo etc)
|
|
# channel 1 is reserved for JTAG (by-default) or SPI (possible via changing solder jumpers)
|
|
ftdi_channel 1
|
|
ftdi_tdo_sample_edge falling
|
|
|
|
|
|
# FTDI Pin Layout
|
|
#
|
|
# +--------+-------+-------+-------+-------+-------+-------+-------+
|
|
# | DBUS7 | DBUS6 | DBUS5 | DBUS4 | DBUS3 | DBUS2 | DBUS1 | DBUS0 |
|
|
# +--------+-------+-------+-------+-------+-------+-------+-------+
|
|
# | PROG_B | OE_N | NC | NC | TMS | TDO | TDI | TCK |
|
|
# +--------+-------+-------+-------+-------+-------+-------+-------+
|
|
#
|
|
# OE_N is JTAG buffer output enable signal (active-low)
|
|
# PROG_B is not used, so left as input to FTDI.
|
|
#
|
|
ftdi_layout_init 0x0008 0x004b
|
|
reset_config none
|
|
adapter_khz 30000
|
|
|
|
source [find cpld/xilinx-xc7.cfg]
|
|
source [find cpld/jtagspi.cfg]
|