4157732bd8
For historical reasons, no license information was added to the
tcl files. This makes trivial adding the SPDX tag through script:
fgrep -rL SPDX tcl/board | while read a;do \
sed -i '1{i# SPDX-License-Identifier: GPL-2.0-or-later\n
}' $a;done
With no specific license information from the author, let's extend
the OpenOCD project license GPL-2.0-or-later to the files.
Change-Id: Ibcf7da62e842aafd036a78db9ea2b9f11f79af16
Signed-off-by: Antonio Borneo <borneo.antonio@gmail.com>
Reviewed-on: https://review.openocd.org/c/openocd/+/7028
Tested-by: jenkins
Reviewed-by: Tarek BOCHKATI <tarek.bouchkati@gmail.com>
33 lines
870 B
INI
33 lines
870 B
INI
# SPDX-License-Identifier: GPL-2.0-or-later
|
|
|
|
# Product page:
|
|
# https://www.8devices.com/products/lima
|
|
#
|
|
# Location of JTAG pins:
|
|
# J2 GPIO0 JTAG TCK
|
|
# J2 GPIO1 JTAG TDI
|
|
# J2 GPIO2 JTAG TDO
|
|
# J2 GPIO3 JTAG TMS
|
|
# J2 RST directly connected to RESET_L of the SoC and can be used as
|
|
# JTAG SRST. Note: this pin will also reset the debug engine.
|
|
# J1 +3,3V Can be use as JTAG Vref
|
|
# J1 or J2 GND Can be used for JTAG GND
|
|
#
|
|
# This board is powered from mini USB connecter which is also used
|
|
# as USB to UART converted based on FTDI FT230XQ chip
|
|
|
|
source [find target/qualcomm_qca4531.cfg]
|
|
|
|
proc board_init { } {
|
|
qca4531_ddr2_550_550_init
|
|
}
|
|
|
|
$_TARGETNAME configure -event reset-init {
|
|
board_init
|
|
}
|
|
|
|
set ram_boot_address 0xa0000000
|
|
$_TARGETNAME configure -work-area-phys 0xa1FFE000 -work-area-size 0x1000
|
|
|
|
flash bank flash0 ath79 0xbf000000 0 0 0 $_TARGETNAME cs0
|