c8f4d82b45
Initial support for SPEAr300 chip and for evaluation board named EVALSPEAr300. Currently supports only those parts in common with SPEAr310. Change-Id: I8075aa721cf3dfaac561ee51e5df4ce9a2992e3e Signed-off-by: Antonio Borneo <borneo.antonio@gmail.com> Reviewed-on: http://openocd.zylin.com/230 Tested-by: jenkins Reviewed-by: Spencer Oliver <spen@spen-soft.co.uk>
27 lines
1.0 KiB
INI
27 lines
1.0 KiB
INI
# Configuration for the ST SPEAr300 Evaluation board
|
|
# EVALSPEAr300 Rev. 1.0, modified to enable SRST on JTAG connector
|
|
# http://www.st.com/spear
|
|
#
|
|
# List of board modifications to enable SRST, as reported in
|
|
# ST Application Note (FIXME: add reference).
|
|
# - Modifications on the top layer:
|
|
# 1. replace reset chip U4 with a STM6315SDW13F;
|
|
# - Modifications on the bottom layer:
|
|
# 2. add 0 ohm resistor R10. It is located close to JTAG connector.
|
|
# 3. add a 10K ohm pull-up resistor on the reset wire named as
|
|
# POWERGOOD in the schematic.
|
|
#
|
|
# The easier way to do modification 3, is to use a resistor in package
|
|
# 0603 and solder it between R10 and R54:
|
|
# - one pad soldered with the pad of R54 connected to 3.3V (this
|
|
# is the pad of R54 far from JTAG connector J4)
|
|
# - the other pad soldered with the nearest pad of R10.
|
|
#
|
|
# Date: 2011-11-18
|
|
# Author: Antonio Borneo <borneo.antonio@gmail.com>
|
|
|
|
|
|
# Modified boards has SRST on JTAG connector
|
|
set BOARD_HAS_SRST 1
|
|
source [find board/spear300evb.cfg]
|