7c38f24529
The patch was created automatically using the following script: %<---%<---%<---%<---%<---%<---%<---%<---%<---%<---%<---%<--- (cat << EOF ftdi_device_desc ftdi device_desc ftdi_serial ftdi serial ftdi_channel ftdi channel ftdi_layout_init ftdi layout_init ftdi_layout_signal ftdi layout_signal ftdi_set_signal ftdi set_signal ftdi_get_signal ftdi get_signal ftdi_vid_pid ftdi vid_pid ftdi_tdo_sample_edge ftdi tdo_sample_edge EOF ) | while read a b; do sed -i "s/$a/$b/g" $(find tcl -type f -name "*.cfg" ) done %<---%<---%<---%<---%<---%<---%<---%<---%<---%<---%<---%<--- Change-Id: Iff781f37bb5511b7e15cbe6dcdf6d28e89fb174f Signed-off-by: Marc Schink <dev@zapb.de> Reviewed-on: http://openocd.zylin.com/6333 Tested-by: jenkins Reviewed-by: Antonio Borneo <borneo.antonio@gmail.com>
35 lines
1.3 KiB
INI
35 lines
1.3 KiB
INI
#
|
|
# Luminary Micro Stellaris Evaluation Kits
|
|
#
|
|
# http://www.luminarymicro.com/products/evaluation_kits.html
|
|
#
|
|
# There are a number of evaluation kits for Stellaris Cortex-M3 chips.
|
|
# Currently they all bundle ftdi based debug support. When that is
|
|
# used (instead of an external adapter), use this config file in one
|
|
# of these two modes:
|
|
#
|
|
# - Eval board debug ... debug of the Stellaris chip via port A.
|
|
#
|
|
# - Other board debug ... same thing, but the board acts as a debug
|
|
# adapter for another board (using a standard ARM JTAG connector).
|
|
# The Stellaris chip stays in reset.
|
|
#
|
|
# Those support both JTAG and SWD. SWD is an ARM-only two-wire debug
|
|
# protocol; in 2009, OpenOCD does not support SWD.
|
|
#
|
|
# Port B of the ftdi chip is normally used as a serial link to the
|
|
# Stellaris chip. On most boards (but not older LM3S811 eval boards),
|
|
# when SWD is used Port B may instead be used to read low-bandwidth
|
|
# "SWO trace" data, including so-called "printf style" output from
|
|
# firmware via the ITM module as well as profile data.
|
|
#
|
|
|
|
adapter driver ftdi
|
|
ftdi device_desc "Stellaris Evaluation Board"
|
|
ftdi vid_pid 0x0403 0xbcd9
|
|
|
|
ftdi layout_init 0x00a8 0x00eb
|
|
ftdi layout_signal nSRST -noe 0x0020
|
|
ftdi layout_signal SWD_EN -ndata 0x0080
|
|
ftdi layout_signal SWDIO_OE -data 0x0008
|