38ac08c1c2
Avoid annoying "deprecated" messages while running the scripts distributed with OpenOCD code. Change automatically created with commands sed -i 's/adapter_khz/adapter speed/g' $(find tcl/ -type f) sed -i 's/adapter_nsrst_delay/adapter srst delay/g' $(find tcl/ -type f) sed -i 's/adapter_nsrst_assert_width/adapter srst pulse_width/g' $(find tcl/ -type f) Minor indentation issue fixed manually in tcl/board/at91sam9g20-ek.cfg tcl/target/at91sam9260_ext_RAM_ext_flash.cfg Change-Id: I425fd56c0c88cd6b06124621306eeb89166dfe71 Signed-off-by: Antonio Borneo <borneo.antonio@gmail.com> Reviewed-on: http://openocd.zylin.com/5284 Tested-by: jenkins Reviewed-by: Oleksij Rempel <linux@rempel-privat.de>
28 lines
1021 B
INI
28 lines
1021 B
INI
# script for ATMEL sam4l, a Cortex-M4 chip
|
|
#
|
|
|
|
source [find target/at91sam4XXX.cfg]
|
|
|
|
set _FLASHNAME $_CHIPNAME.flash
|
|
flash bank $_FLASHNAME at91sam4l 0x00000000 0 1 1 $_TARGETNAME
|
|
|
|
# SAM4L SMAP will hold the CPU in reset if TCK is low when RESET_N
|
|
# deasserts (see datasheet 42023E-SAM-07/2013 sec 8.11.3).
|
|
#
|
|
# smap_reset_deassert configures whether we want to run or halt out of reset,
|
|
# then instruct the SMAP to let us out of reset.
|
|
$_TARGETNAME configure -event reset-deassert-post "at91sam4l smap_reset_deassert"
|
|
|
|
# SRST (wired to RESET_N) resets debug circuitry
|
|
# srst_pulls_trst is not configured here to avoid an error raised in reset halt
|
|
reset_config srst_gates_jtag
|
|
|
|
# SAM4L starts from POR with SYSCLK set to 115kHz RCSYS, needs slow JTAG speed.
|
|
# Datasheet does not specify SYSCLK to JTAG/SWD clock ratio.
|
|
# Usually used SYSCLK/6 is hell slow, testing shows that debugging can work @ SYSCLK/2
|
|
# but your mileage may vary.
|
|
adapter speed 50
|
|
|
|
# System RC oscillator RCSYS starts in 3 cycles
|
|
adapter srst delay 0
|