38ac08c1c2
Avoid annoying "deprecated" messages while running the scripts distributed with OpenOCD code. Change automatically created with commands sed -i 's/adapter_khz/adapter speed/g' $(find tcl/ -type f) sed -i 's/adapter_nsrst_delay/adapter srst delay/g' $(find tcl/ -type f) sed -i 's/adapter_nsrst_assert_width/adapter srst pulse_width/g' $(find tcl/ -type f) Minor indentation issue fixed manually in tcl/board/at91sam9g20-ek.cfg tcl/target/at91sam9260_ext_RAM_ext_flash.cfg Change-Id: I425fd56c0c88cd6b06124621306eeb89166dfe71 Signed-off-by: Antonio Borneo <borneo.antonio@gmail.com> Reviewed-on: http://openocd.zylin.com/5284 Tested-by: jenkins Reviewed-by: Oleksij Rempel <linux@rempel-privat.de>
49 lines
1.1 KiB
INI
49 lines
1.1 KiB
INI
# Target configuration for the Samsung 2450 system on chip
|
|
# Processor : ARM926ejs (wb) rev 0 (v4l)
|
|
# Info: JTAG tap: s3c2450.cpu tap/device found: 0x07926F0F
|
|
|
|
|
|
# FIX!!! what to use here?
|
|
#
|
|
# RCLK?
|
|
#
|
|
# adapter speed 0
|
|
#
|
|
# Really low clock during reset?
|
|
#
|
|
# adapter speed 1
|
|
|
|
if { [info exists CHIPNAME] } {
|
|
set _CHIPNAME $CHIPNAME
|
|
} else {
|
|
set _CHIPNAME s3c2450
|
|
}
|
|
|
|
if { [info exists ENDIAN] } {
|
|
set _ENDIAN $ENDIAN
|
|
} else {
|
|
# this defaults to a bigendian
|
|
set _ENDIAN little
|
|
}
|
|
|
|
if { [info exists CPUTAPID] } {
|
|
set _CPUTAPID $CPUTAPID
|
|
} else {
|
|
set _CPUTAPID 0x07926f0f
|
|
}
|
|
|
|
#jtag scan chain
|
|
jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0xE -irmask 0x0f -expected-id $_CPUTAPID
|
|
|
|
set _TARGETNAME $_CHIPNAME.cpu
|
|
target create $_TARGETNAME arm926ejs -endian $_ENDIAN -chain-position $_TARGETNAME
|
|
|
|
# FIX!!!!! should this really use srst_pulls_trst?
|
|
# With srst_pulls_trst "reset halt" will not reset into the
|
|
# halted mode, but rather "reset run" and then halt the target.
|
|
#
|
|
# However, without "srst_pulls_trst", then "reset halt" produces weird
|
|
# errors:
|
|
# WARNING: unknown debug reason: 0x0
|
|
reset_config trst_and_srst
|