faedb14772
This adds the bcm47xx config with the special undocumented trick to put it into standard EJTAG mode from the mystic "LV mode". The RAM setup is not done as it would require considerable efforts without much practical gain. The only issue I noticed so far is that "reset" doesn't actually reset the chip. Unfortunately, it's unclear how to make it work properly with SRST as OpenOCD asserts it in MIPS-specific code so the device will enter LV mode again but the LV tap is already disabled by that time, so it's not possible to send the magic command again. Anyway, this config is more than enough to "recover" any RT-N16 provided the hardware is not damaged. Change-Id: I0894e339763e6d20d1c93341c597382b479d039b Signed-off-by: Paul Fertser <fercerpav@gmail.com> Reviewed-on: http://openocd.zylin.com/1849 Tested-by: jenkins Reviewed-by: Spencer Oliver <spen@spen-soft.co.uk>
16 lines
423 B
INI
16 lines
423 B
INI
#
|
|
# http://wikidevi.com/wiki/ASUS_RT-N16
|
|
#
|
|
|
|
set partition_list {
|
|
CFE { Bootloader 0xbc000000 0x00040000 }
|
|
firmware { "Kernel+rootfs" 0xbc040000 0x01fa0000 }
|
|
nvram { "Config space" 0xbdfe0000 0x00020000 }
|
|
}
|
|
|
|
source [find target/bcm4718.cfg]
|
|
|
|
# External 32MB NOR Flash (Macronix MX29GL256EHTI2I-90Q)
|
|
set _FLASHNAME $_CHIPNAME.flash
|
|
flash bank $_FLASHNAME cfi 0xbc000000 0x02000000 1 1 $_TARGETNAME x16_as_x8
|