7c38f24529
The patch was created automatically using the following script: %<---%<---%<---%<---%<---%<---%<---%<---%<---%<---%<---%<--- (cat << EOF ftdi_device_desc ftdi device_desc ftdi_serial ftdi serial ftdi_channel ftdi channel ftdi_layout_init ftdi layout_init ftdi_layout_signal ftdi layout_signal ftdi_set_signal ftdi set_signal ftdi_get_signal ftdi get_signal ftdi_vid_pid ftdi vid_pid ftdi_tdo_sample_edge ftdi tdo_sample_edge EOF ) | while read a b; do sed -i "s/$a/$b/g" $(find tcl -type f -name "*.cfg" ) done %<---%<---%<---%<---%<---%<---%<---%<---%<---%<---%<---%<--- Change-Id: Iff781f37bb5511b7e15cbe6dcdf6d28e89fb174f Signed-off-by: Marc Schink <dev@zapb.de> Reviewed-on: http://openocd.zylin.com/6333 Tested-by: jenkins Reviewed-by: Antonio Borneo <borneo.antonio@gmail.com>
17 lines
422 B
INI
17 lines
422 B
INI
# TMS570 Microcontroller USB Kit
|
|
# http://www.ti.com/tool/TMDX570LS20SUSB
|
|
|
|
# Board uses a FT2232H to emulate an XDS100v2 JTAG debugger
|
|
# TODO: board also supports an SCI UART on the 2232's B Bus
|
|
source [find interface/ftdi/xds100v2.cfg]
|
|
|
|
# Processor is TMS570LS20216
|
|
source [find target/ti_tms570ls20xxx.cfg]
|
|
|
|
reset_config trst_only
|
|
|
|
# xds100v2 config says add this to the end
|
|
init
|
|
ftdi set_signal PWR_RST 1
|
|
jtag arp_init
|