4157732bd8
For historical reasons, no license information was added to the
tcl files. This makes trivial adding the SPDX tag through script:
fgrep -rL SPDX tcl/board | while read a;do \
sed -i '1{i# SPDX-License-Identifier: GPL-2.0-or-later\n
}' $a;done
With no specific license information from the author, let's extend
the OpenOCD project license GPL-2.0-or-later to the files.
Change-Id: Ibcf7da62e842aafd036a78db9ea2b9f11f79af16
Signed-off-by: Antonio Borneo <borneo.antonio@gmail.com>
Reviewed-on: https://review.openocd.org/c/openocd/+/7028
Tested-by: jenkins
Reviewed-by: Tarek BOCHKATI <tarek.bouchkati@gmail.com>
28 lines
1.0 KiB
INI
28 lines
1.0 KiB
INI
# SPDX-License-Identifier: GPL-2.0-or-later
|
|
|
|
# Configuration for the ST SPEAr310 Evaluation board
|
|
# EVALSPEAr310 Rev. 2.0, modified to enable SRST on JTAG connector
|
|
# http://www.st.com/spear
|
|
#
|
|
# List of board modifications to enable SRST, as reported in
|
|
# ST Application Note AN3321.
|
|
# - Modifications on the top layer:
|
|
# 1. remove R137 and C57, located near the SMII PHY U18;
|
|
# 2. remove R172 and C75, located near the SMII PHY U19;
|
|
# 3. remove R207 and C90, located near the SMII PHY U20;
|
|
# 4. remove C236, located near the SMII PHY U21;
|
|
# 5. remove U12, located near the JTAG connector;
|
|
# 6. solder together pins 7, 8 and 9 of U12;
|
|
# 7. solder together pins 11, 12, 13, 14, 15, 16, 17 and 18 of U12.
|
|
# - Modifications on the bottom layer:
|
|
# 8. replace reset chip U11 with a STM6315SDW13F;
|
|
# 9. add 0 ohm resistor R329. It is located close to JTAG connector.
|
|
#
|
|
# Date: 2009-10-31
|
|
# Author: Antonio Borneo <borneo.antonio@gmail.com>
|
|
|
|
|
|
# Modified boards has SRST on JTAG connector
|
|
set BOARD_HAS_SRST 1
|
|
source [find board/spear310evb20.cfg]
|