1c021ed0af
Remove this underutilized feature. Despite the fact that a lot of configs specifies a arbitrary "variant", only the xscale target actually defines any. In the case of xscale, the use of -variant is dubious since 1) it's used as a redundant irlen specifier, 2) it carries a comment that it doesn't really need it and 3) only two xscale configs even specify it. If there's a future target that needs a variant set, a target specific option could be added when needed. Change-Id: I1ba25a946f0d80872cbd96ddcc48f92695c4ae20 Signed-off-by: Andreas Fritiofson <andreas.fritiofson@gmail.com> Reviewed-on: http://openocd.zylin.com/2283 Tested-by: jenkins Reviewed-by: Spencer Oliver <spen@spen-soft.co.uk>
38 lines
803 B
INI
38 lines
803 B
INI
######################################
|
|
# Target: Atmel AT91SAM9
|
|
######################################
|
|
|
|
if { [info exists AT91_CHIPNAME] } {
|
|
set _CHIPNAME $AT91_CHIPNAME
|
|
} else {
|
|
error "you must specify a chip name"
|
|
}
|
|
|
|
if { [info exists ENDIAN] } {
|
|
set _ENDIAN $ENDIAN
|
|
} else {
|
|
set _ENDIAN little
|
|
}
|
|
|
|
if { [info exists CPUTAPID] } {
|
|
set _CPUTAPID $CPUTAPID
|
|
} else {
|
|
set _CPUTAPID 0x0792603f
|
|
}
|
|
|
|
reset_config trst_and_srst separate trst_push_pull srst_open_drain
|
|
|
|
jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id $_CPUTAPID
|
|
|
|
adapter_nsrst_delay 300
|
|
jtag_ntrst_delay 200
|
|
|
|
adapter_khz 3
|
|
|
|
######################
|
|
# Target configuration
|
|
######################
|
|
|
|
set _TARGETNAME $_CHIPNAME.cpu
|
|
target create $_TARGETNAME arm926ejs -endian $_ENDIAN -chain-position $_TARGETNAME
|