5ad98c57b8
The CONFIG_MACPWR Kconfig symbol is used to point to a GPIO that enables the power for the Ethernet "MAC" (mostly PHY, really). In the DT this is described with the phy-supply property in the MAC DT node, pointing to a (GPIO controlled) regulator. Since we need Ethernet only in U-Boot proper, and use a DM driver there, we should use the DT instead of hardcoding this. Add code to the sun8i_emac and sunxi_emac drivers to check the DT for that regulator and enable it, at probe time. Then drop the current code from board.c, which was doing that job before. This allows us to remove the MACPWR Kconfig definition and the respective values from the defconfigs. Signed-off-by: Andre Przywara <andre.przywara@arm.com> Reviewed-by: Sam Edwards <CFSworks@gmail.com>
26 lines
549 B
Plaintext
26 lines
549 B
Plaintext
CONFIG_ARM=y
|
|
CONFIG_ARCH_SUNXI=y
|
|
CONFIG_DEFAULT_DEVICE_TREE="sun7i-a20-bananapi"
|
|
CONFIG_SPL=y
|
|
CONFIG_MACH_SUN7I=y
|
|
CONFIG_DRAM_CLK=432
|
|
CONFIG_VIDEO_COMPOSITE=y
|
|
CONFIG_GMAC_TX_DELAY=3
|
|
CONFIG_AHCI=y
|
|
# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
|
|
CONFIG_SPL_I2C=y
|
|
CONFIG_NETCONSOLE=y
|
|
CONFIG_SCSI_AHCI=y
|
|
CONFIG_SYS_64BIT_LBA=y
|
|
CONFIG_SYS_I2C_MVTWSI=y
|
|
CONFIG_SYS_I2C_SLAVE=0x7f
|
|
CONFIG_SYS_I2C_SPEED=400000
|
|
CONFIG_PHY_REALTEK=y
|
|
CONFIG_ETH_DESIGNWARE=y
|
|
CONFIG_RGMII=y
|
|
CONFIG_MII=y
|
|
CONFIG_SUN7I_GMAC=y
|
|
CONFIG_SCSI=y
|
|
CONFIG_USB_EHCI_HCD=y
|
|
CONFIG_USB_OHCI_HCD=y
|