u-boot/configs/Orangepi_mini_defconfig
Andre Przywara 5ad98c57b8 sunxi: remove CONFIG_MACPWR
The CONFIG_MACPWR Kconfig symbol is used to point to a GPIO that enables
the power for the Ethernet "MAC" (mostly PHY, really).
In the DT this is described with the phy-supply property in the MAC DT
node, pointing to a (GPIO controlled) regulator. Since we need Ethernet
only in U-Boot proper, and use a DM driver there, we should use the DT
instead of hardcoding this.

Add code to the sun8i_emac and sunxi_emac drivers to check the DT for
that regulator and enable it, at probe time. Then drop the current code
from board.c, which was doing that job before.
This allows us to remove the MACPWR Kconfig definition and the respective
values from the defconfigs.

Signed-off-by: Andre Przywara <andre.przywara@arm.com>
Reviewed-by: Sam Edwards <CFSworks@gmail.com>
2023-10-22 23:40:56 +01:00

28 lines
620 B
Plaintext

CONFIG_ARM=y
CONFIG_ARCH_SUNXI=y
CONFIG_DEFAULT_DEVICE_TREE="sun7i-a20-orangepi-mini"
CONFIG_SPL=y
CONFIG_MACH_SUN7I=y
CONFIG_DRAM_CLK=432
CONFIG_MMC_SUNXI_SLOT_EXTRA=3
CONFIG_USB1_VBUS_PIN="PH26"
CONFIG_USB2_VBUS_PIN="PH22"
CONFIG_VIDEO_COMPOSITE=y
CONFIG_GMAC_TX_DELAY=3
CONFIG_AHCI=y
# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
CONFIG_SPL_I2C=y
CONFIG_SCSI_AHCI=y
CONFIG_SYS_64BIT_LBA=y
CONFIG_SYS_I2C_MVTWSI=y
CONFIG_SYS_I2C_SLAVE=0x7f
CONFIG_SYS_I2C_SPEED=400000
CONFIG_PHY_REALTEK=y
CONFIG_ETH_DESIGNWARE=y
CONFIG_RGMII=y
CONFIG_MII=y
CONFIG_SUN7I_GMAC=y
CONFIG_SCSI=y
CONFIG_USB_EHCI_HCD=y
CONFIG_USB_OHCI_HCD=y