1.5 KiB
1.5 KiB
Overview
The Xbara project is a simple demonstration program of the SDK Xbara driver.The intended application of this module is to provide a flexible crossbar switch function that allows any input to be connected to any output under user control.It sets up the Xbara hardware block to trigger a periodic interrupt after every 1 second. When the Xbar interrupt is triggered a message a printed on the UART terminal.
SDK version
- Version: 2.15.000
Toolchain supported
- IAR embedded Workbench 9.40.1
- Keil MDK 5.38.1
- GCC ARM Embedded 12.2
- MCUXpresso 11.8.0
Hardware requirements
- Mini/micro USB cable
- IMXRT1050-EVKB board
- Personal Computer
Board settings
No special settings are required.
Prepare the Demo
- Connect a USB cable between the PC host and the OpenSDA USB port on the board.
- Open a serial terminal with these settings:
- 115200 baud rate
- 8 data bits
- No parity
- One stop bit
- No flow control
- Download the program to the target board.
- Either press the reset button on your board or launch the debugger in your IDE to begin running the example.
Running the demo
These instructions are displayed/shown on the terminal window:
XBARA Peripheral Driver Example.
XBARA interrupt is occurred !
XBARA interrupt is occurred !
XBARA interrupt is occurred !
............................
............................