1.6 KiB
1.6 KiB
Overview
This example illustrates USBX Device Mass Storage.
SDK version
- Version: 2.15.000
Toolchain supported
- IAR embedded Workbench 9.40.1
- Keil MDK 5.38.1
- GCC ARM Embedded 12.2
- MCUXpresso 11.8.0
Hardware requirements
- Mini/micro USB cable
- Target Board
- Personal Computer(PC)
Board settings
No special settings are required.
Prepare the Demo
- Connect a USB cable between the host PC and the OpenSDA USB port on the target board.
- Open a serial terminal with the following settings:
- 115200 baud rate
- 8 data bits
- No parity
- One stop bit
- No flow control
- Compile the demo with the configuration, "flexspi_nor_debug".
- Write the program to the flash of the target board.
- Press the reset button on your board to start the demo.
- Connect a USB cable between the PC and the USB device port of the board.
- PC can format/read/write this u-disk. Running the demo ================ After writing the program to the flash of the target board, press the reset button on your board to start the demo. The serial port will output:
USBX device mass storage example
Then, connect a USB cable between PC and USB device port of the board. The serial port will output:
USB MSD device activate
PC will detect a u-disk and can format it. After format is completed, the PC will display a removable disk and it can be used as a normal u-disk.
Please note that the USBX Device Mass Storage example use RAM disk as storage media, data will lost after board is reset.